Trango Broadband M5580M-FSU - Manual (Page 16)

Configuration
Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2 page 12
AP Autoscan Software switch (1) is to sw 1 [] (default is on)
turn AP autoscan on or off.
TCP/IP for AP Software switch (2), when on,
allows users at the AP side sw 2 [] (default is on)
of the network to telnet or
HTTP into the SU.
HTTP services Software switch (5), when on,
allows local access via the
browser sw 5 [] (default is on)
TCP/IP for Local Ethernet This software switch (switch
6) when on, allows users on
the wired side of the SU to
telnet or HTTP into the SU.
sw 6 [] (default is on)
Remarks User definable radio remarks []
information (i.e. customer Example:
name, address of installation, #>remarks 678 Oak Ave
and so on). Stores a
maximum of 28
characters can be stored.
Counters: These are averages of wired Informational Parameter
RF TX RF RX and wireless, transmit and
Eth TX Eth RX received, traffic in Kbps.
Establishing a Wireless Link
If the AP and SU are properly configured and in opmode “ON”, the two radios will automatically begin the
authentication process and become connected. To determine if the two radios are connected, type the
sysinfo command.
Example:
#> sysinfo
[Hardware Version] 5580
[MVC Version] 3893mvc_4p5_050913.arm
[Firmware Version] FSU 2p0r8D06011801
[Device ID] 00 01 DE 00 04 47 [Base ID] 1 [AP ID] 1 [SU ID] 1
[System Up Time] 0 day(s) 00:34:15
[Opmode] off [Default Opmode] off [Opmode Start] 30 sec
[IP] 192.168.100.100 [Subnet Mask] 255.255.255.0 [Gateway] 192.168.100.1
[Httpd Port] 80 [Httpd Status] listen
[Telnetd Port] 23 [Telnetd Status] connected
[Telnet Client #1] 192.168.100.111,1092
[Tftpd] disabled
[RF Tx Power] 21 dBm
Channel Table: (MHz)
[Ch#01] 5736 [Ch#02] 5756 [Ch#03] 5776 [Ch#04] 5796 [Ch#05] 5816 [Ch#06] 5836
[Ch#07] 5736 [Ch#08] 5736 [Ch#09] 5736 [Ch#10] 5736 [Ch#11] 5736 [Ch#12] 5736
[Ch#13] 5736 [Ch#14] 5736 [Ch#15] 5736 [Ch#16] 5736 [Ch#17] 5736 [Ch#18] 5736
[Ch#19] 5736 [Ch#20] 5736 [Ch#21] 5736 [Ch#22] 5736 [Ch#23] 5736 [Ch#24] 5736
[Ch#25] 5736 [Ch#26] 5736 [Ch#27] 5736 [Ch#28] 5736 [Ch#29] 5736 [Ch#30] 5736
[Channel Scan Sequence] 1 h
[Active Channel]
1 h Disconnected
[Broadcast Packet] on [Auto Scan AP] on [TCP/IP for AP] off [TCP/IP for Local Eth] off