Trango Broadband M5580M-FSU User Manual
Page 15
Configuration
Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2
page
11
to execute commands from the #>Set suid 3
AP to this specific SU.
AP ID
Informational parameter that
shows to which AP the SU is
Informational Parameter
associated. Please note that
AP ID is not used by the
system for SU authentication.
Opmode
Current Opmode of radio.
opmode su [< y>] / off
This sets the radio in Opmode “SU.” Or OFF
Default Opmode
Determines the Opmode (“SU”
or “OFF”) of the radio after
reboot/power cycle. When the
parameter is set to “SU,” the
radio will progress into
Opmode “SU” automatically
fter reboot/power cycle.
set defaultopmode
IP
Subnet
Gateway
IP, Subnet, and Gateway
address of radio.
ipconfig [
TFTPD
TFTPD status (on or off).
TFTPD should be turned on to
tftpd [
import file into radio (such as
new firmware). Default is off.
TFTPD will revert to off after
reboot/power cycle.
RF TX Power
Current transmit power of the
power set
SU not including antenna gain.
This is controlled during the
association process.
Channel Scan Sequence
Shows the various channels (in
sequence) that the SU will
freq scantable (displays scan table)
scan while searching for an
freq scantable 5 v (sets Scan table to 5 v)
AP.
Active Channel
Shows the channel used in the
Information Parameter
current association, and
"Associated" or
"Disconnected" depending on
the association status.
Broadcast Packet Filter
This software switch (0)
sw 0 [
enables/disables the blocking
of Ethernet control packets,
Example:
except ICMP and ARP, to
#>sw 0 on
reduce the amount of
unnecessary overhead
introduced to the wireless link.