Toshiba B-415 - Manual (Page 3)

(i)
Safety Summary ENGLISH VERSION EO1-33014
The B-415-GH25-QM is equipped with a wireless communication device, TEC-BTM. Please be sure to
read the enclosed Precautions for Handling of Wireless Communication Devices before using this product.
Precautions for Handling of Wireless Communication Devices
Bluetooth
® Module: TEC-BTM
Trade Mark
Bluetooth is a trademark owned by Bluetooth SIG, Inc. and used by TOSHIBA TEC CORPORATION
under license from Japan Total Design Communication Co., Ltd.
The B-415-GH25-QM is equipped with a certified wireless communication module (TEC-BTM). The
following cautions are applied to the certified wireless module.
Cautions
General
For all countries and areas
This product is a wireless communication device, and the use of this product is restricted to the following
countries or areas. If the product is used in the countries or areas other than the following, you may be
punished according to the laws of those countries or areas.
Japan, USA, Canada, Austria, Belgium, Denmark, Finland, France, Germany, Greece, Italy, Ireland,
Luxembourg, Portugal, Spain, Sweden, The Netherlands, United Kingdom, Australia, New Zealand,
Mexico, Switzerland, Norway, Iceland, Hungary, Liechtenstein
For Europe
Hereby, TOSHIBA TEC CORPORATION, declares that this TEC-BTM is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
This equipment uses a radio frequency band that has not been harmonised throughout all EU and EFTA
countries, and can be used in the following countries.
Austria, Belgium, Denmark, Finland, France, Germany, Greece, Italy, Ireland, Luxembourg, Portugal,
Spain, Sweden, The Netherlands, United Kingdom, Switzerland, Norway, Iceland, Hungary, Liechtenstein
For USA
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modification not expressly approved by manufacturer for compliance could void the user’s
authority to operate the equipment.
For Canada
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the device.