Toshiba B-415 - Manual (Page 22)

ENGLISH VERSION EO1-33014
CAUTIONS:
1. Radio communication between a handy terminal and the B-415 printer is guaranteed when the
handy terminal is in the operator’s hand and the printer is secured at the waist. Proper radio
communication may not be obtained when used in other conditions and in areas subject to
noise and radio interference.
2. Be sure to disconnect the RS-232C interface cable from the printer before performing radio
communication or IrDA.
3. To perform the radio communication or IrDA, the printer must be synchronized with the handy
terminal.
4. IrDA is available on the conditions indicated below. The following performance is obtained
under fluorescent light (max. 1000 lx). Care must be taken to prevent direct sunlight from
entering the IrDA interface window.
8. ISSUING THE MEDIA
8. ISSUING THE MEDIA
Printer
Handy
Terminal
max. 30 cm
Printer
Handy
Terminal
max. 30 cm
1. Turn on the printer.
Fig. 8-1
3. Issuing labels
1) The number of labels is specified when issuing labels in batch mode. To re-issue the label,
press the [FEED] button.
This operation differs, depending on the print mode.
2) The printer prints labels one by one in strip mode by pressing the [FEED] button. To issue more
than one label, remove the printed label before issuing the next one.
This operation differs, depending on the print mode.
NOTE: Trim off the backing paper coming from the backing paper outlet.
3) After printing the receipt, press the [FEED] button to feed it to a position where it can be easily
cut. Each time the [FEED] button is pressed, the receipt is fed for 20 mm.
NOTE: Firmly slide the power switch to the position “ON” or “OFF” until it clicks. If you slide the
power switch in halfway, the printer may not judge the power ON/OFF status.
2. Send data from the handy terminal to the printer. (Regarding the operation of the handy terminal,
please refer to the handy terminal’s operating manual.)
(Radio Communication Sample)
8. ISSUING THE MEDIA
E8-1