Tascam CD-VT1MKII - Manual (Page 11)

TASCAM CD-VT1MKII —
11
Part names and functions (Continued)
14) STOP/MTRO Key [
H
]
Press this key to stop playback. Press-
ing and holding this key down activates
the metronome menu (See Using the
metronome).
15) PLAY/PAUSE Key [
G
/
J
]
Use this key to start playing a CD.
While a CD is playing, you can pause
playback by pressing this key. Press
again to resume playing.
16) CUE Key
Use this key to return to the cue point
(the point where playback last started).
Use the Setup menu to choose a mode
that the CUE key can perform (See
Changing your preferences).
17) PHONES Jack
Connect your headphones here.
18) LINE OUT Jack
Use this port to connect the CD-
VT1MKII to devices such as speakers
with a built-in amplifier, a stereo sys-
tem AUX input jack, a cassette tape re-
corder, or a CD recorder. You can hear
the results of the effects and key chang-
es through devices connected here.
19) OUTPUT Control
Use this control to adjust the output
level of the PHONES jack and the LINE
OUT jack. This control adjusts the level
of the two jacks together (the two jack
levels cannot be adjusted separately).
20) INPUT Control
Use this control to adjust the input
level of MIC IN jacks 1 and 2. This
control adjusts the input level of MIC
IN 1 jack and MIC IN 2 jack together
(the levels of the two jacks cannot be
adjusted separately).
21) LINE IN Jack
Use this stereo jack to connect external
devices such as a synthesizer, cassette
tape recorder, rack-mount effect unit,
etc., to the CD-VT1MKII. This jack
has no level control, so you must adjust
the output level at the source device.
22) MIC IN 1 Jack
Connect a microphone to this jack.
23) MIC IN 2 Jack
Connect a microphone to this jack.
24) POWER Switch
This switch turns the power to the
whole unit on and off.
25) CD EFF Switch
Use this switch to turn CD effects on
and off.
26) EFFECT ON/OFF Switch
This switch turns the effector and voice
change on and off. When this switch is
ON, the display shows EFFECT .