Tektronix PHASER 240 - Manual (Page 185)

Using Different Printer Language Modes C
Printing Reference C-3
To change CONFIG.PS to specify different timeouts, substitute
new values for 0 and 40 in the JobTimeOut and WaitTimeOut
lines. Permitted timeout values are as follows:
■ JobTimeOut : 0 to 999
■ WaitTimeOut : 0, or 15 to 999
■ ManualFeedTimeout: 0 to 999
■ To specify no timeout, use 0
Note To avoid timeouts or job cancellation on Windows multiple-page
or multiple-copy print jobs, you may want to set the
WaitTimeOut
to a high value or to 0 (zero).
In the following example, the timeouts are set to their
default values.
3 dict begin
/Password() def
/JobTimeOut 0 def
/WaitTimeOut 40 def
currentdict end setsystemparams
1 dict begin
currentpagedevice /ManualFeedTimeout known
{ /ManualFeedTimeout 60 def } if
currentdict end setpagedevice
5. Use one of the following methods to send the file to the printer:
■ PC users : Use the DOS COPY command, described on page 3-19,
to send the CONFIG.PS file to the printer.
Or, use the Copy command in Windows File Manager, described
on page 3-20, to send the CONFIG.PS file to the printer.
■ Workstation users: Send the CONFIG.PS file to the printer as you
would any PostScript file.