TurboChef Technologies TurboChef User Manual
Page 29
USER CONFIGURABLE OPTIONS - ENABLE/DISABLE CODES
The following codes
enable
and
disable
each function/screen listed. They do not take you to the function/screen.
After each code, press
ENTER
. To enable, press 9 after entering code (except
S
-
A
-
V
-
E
,
W
-
A
-
V
-
E
). To disable, press
any key (except 9) after entering code.
Function/Screen
Simultaneously Press
Enter Key Code
Done Screen w/out “Save Time”
BACK
&
ENTER
3-6-6-3 (D-O-N-E)
Done Screen w/ “Save Time” - step 1
BACK
&
ENTER
3-6-6-3 (D-O-N-E)
Done Screen w/ “Save Time” - step 2
BACK
&
ENTER
8-4-6-3 (T-I-M-E)
Edit Recipe Mode
UP
&
DOWN
8-4-3-3 (T-I-D-E)
Load Menu from Card
BACK
&
ENTER
6-3-6-8 (M-E-N-U)
Save Menu to Card - step 1
BACK
&
ENTER
6-3-6-8 (M-E-N-U)
Save Menu to Card - step 2
BACK
&
ENTER
7-2-8-3 (S-A-V-E)
Snooze Screen
BACK
&
ENTER
7-6-6-9 (S-N-O-Z)
Time Screen (Figure 16)
BACK
&
ENTER
8-4-6-3 (T-I-M-E)
Timed Mag Test
BACK
&
ENTER
9-2-8-3 (W-A-V-E)
- Some codes are not available on some ovens.
- Oven must be in Off or Cooling Down mode.
USER CONFIGURABLE OPTIONS - ACCESS CODES
The following codes allow access to each function/screen listed. To enable/disable these codes (where applicable),
see above. After each code, press
ENTER
.
Function/Screen
Simultaneously Press
Enter Key Code
Edit Recipe Mode
UP
&
DOWN
9 (or as specified - see “Set PIN” below)
Erase Menu*
BACK
&
ENTER
3-7-2-7 (E-R-A-S)
Load Menu from Card
Bottom-left, then upper-mid soft key
Master Reset
BACK
&
ENTER
9-4-7-1
Save Menu to Card
Bottom-left, then lower-mid soft key
Set PIN**
UP
&
DOWN
3-3-4-8 (E-D-I-T)
Test Mode
BACK
&
ENTER
9-4-2-8 (W-H-A-T)
Unit Test
BACK
&
ENTER
8-6-4-8 (U-N-I-T)
View Cook Counts
1 & 3
View Faults***
4 & 6
Zero Cook Counts*
BACK
&
ENTER
6-7-3-9 (O-R-E-Z)
- Oven must be in Off or Cooling Down mode.
* To execute, press 3 after entering code.
** Set PIN after entering code. Accessing “Edit Recipe Mode” will now require new PIN instead of 9.
*** To view voltage, press ENTER. To initiate a self test, press the corresponding soft key from the voltage screen.
19
THE CONTROL SYSTEM