Trilogy Touch Technology Trilogy Commander Digital Intercom 9 - Manual (Page 52)

Commander Installation Guide
Page 52 of 81 Trilogy Communications Limited Issue 9
6.2.2 STARTING THE PROGRAMME
From the Start menu, select the item “TTprog” to launch the program. The window shown
below is displayed.
From the drop-down list, select the type of hardware to be reprogrammed (see Section 6.1).
To update the hardware, a revised “bin” file is required. This may be supplied: -
• on floppy disk
• by
e-mail
• from the internet
If the file has been supplied in zip format, it should be decompressed to a local drive.
Use the “Browse” button to locate the file. The example below shows the program
configured to program a 500-02-11 Talkback Controller with a file named 416_469.bin.