Tripp Lite B064-016 - Manual (Page 12)

12
Installation
Hotkey Command Summary Table
Action Hotkey Command
Activate Hotkey Setting Mode Press and hold the [Num Lock] key, press and release the
minus [-] key, release the [Num Lock] key.
Change Hotkey Setting Mode activation command to
[
Ctrl], [F12]
Activate Hotkey Setting Mode, [H]
Toggle OSD Menu Activation command between [ Scroll
Lock] [Scroll Lock], [Ctrl] [Ctrl] and [Alt] [Alt]
Activate Hotkey Setting Mode, [T]
Note: When using [Ctrl] [Ctrl] or [Alt] [Alt], you must hit the
same [Ctrl] or [Alt] key both times
Selecting the active port Activate Hotkey Setting Mode, [Port ID], [Enter]
Initiate an Auto Scan Activate Hotkey Setting Mode, [ A], [Enter]. Press the [P] key
to pause, and the [ Esc] key or [Spacebar] key to exit. When
paused, pressing any key will resume scanning.
Initiate an Auto Scan at a desired time interval Activate Hotkey Setting Mode, [ A], n, [Enter]
Note: n is a Scan Interval from 1 to 255 seconds. Press the
[P] key to pause, and the [Esc] key or [Spacebar] key to
exit. When paused, pressing any key will resume scanning
Initiate Skip Mode and go to the next port Activate Hotkey Setting Mode, [g]
Note: Once in Skip Mode, press an arrow key [i, h, g, f] to
skip through ports. Press the [Esc] key or [Spacebar] key to
exit
Initiate Skip Mode and go to the previous port Activate Hotkey Setting Mode, [f]
Note: Once in Skip Mode, press an arrow key [i, h, g, f] to
skip through ports. Press the [Esc] key or [Spacebar] key to
exit
Initiate Skip Mode and go to the last port in the installation Activate Hotkey Setting Mode, [h]
Note: Once in Skip Mode, press an arrow key [i, h, g, f] to
skip through ports. Press the [Esc] key or [Spacebar] key to
exit
Initiate Skip Mode and go to the first port in the installation Activate Hotkey Setting Mode, [i] Note: Once in Skip Mode,
press an arrow key [i, h, g, f] to skip through ports. Press
the [Esc] key or [Spacebar] key to exit
Computer Keyboard/Mouse Reset Activate Hotkey Setting Mode, [ F5]
Turning Beeper On/Off Activate Hotkey Setting Mode, [ B]
Setting port operating system (Administrator only) Activate Hotkey Setting Mode, [ F1, F2 or F3]
[ F1] sets the OS to Windows, [F2] to Mac and [F3] to Sun
Restore the OSD default values (Administrator only) Activate Hotkey Setting Mode, [ R], [Enter]