27 one-touch timer recording (otr) – Toshiba SD-37VBSB User Manual
Page 27
27
One-touch Timer Recording (OTR)
3
4
OTR 1 : 30
CH 29
“REC” will keep blinking
in the display.
VCR
1
2
VCR
CH 29
OTR 0:30
INDEX
REC
VCR
The one-touch timer recording feature
provides a simple and convenient way
to make a timed recording.
Note:
If the tape supply has not sufficed for OTR
recording, the clock symbol (
) will blink
at the tape-end and then VCR mode will
change to DVD mode.
In this case, press TIMER REC to cancel
the
blink or press EJECT on the DVD/
VCR to remove the cassette tape.
Preparation
• Turn ON the TV and set to the AV input mode.
• Press VCR to select the VCR mode. (The VCR indicator will
light.)
Load a blank cassette tape with the erase
prevention tab intact. (The DVD/VCR will
automatically turn on.)
Select the program(e.g.29) you want to record with CH +/– or
number buttons.
1~9 : e.g. 5 = press “5”
10~80 : e.g. 29 = press “2” and “9”.
If a recording in Long Play mode
is intended, press SP/LP to dis-
play "LP".
Press REC/OTR twice. The recording will start and stop after 30
minutes. Each additional press of
REC/OTR will increase the record-
ing time to a maximum of 6 hours
(See table below).
If REC/OTR is pressed once during the recording, the remain-
ing time appears on the screen. When pressed again, the re-
cording time is extended to the nearest 30-minute or 1-hour
interval.
To Extend the Recording Time
Press REC/OTR repeatedly until the
desired time appears on the display.
To stop the OTR
Press STOP.
00:00:00 LP
2:00
5:00
4:00
3:00
1:30
Recording
0:30
1:00
6:00
2J50101A [EN] P25-32
27/2/06, 5:39 PM
27