Toshiba SD-37VBSB - Manual (Page 11)

11
Remote control
1 2 3
Replace the compartment
cover. Install two "R03/AAA" batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment. Open the battery compart-
ment cover in the direction of
the arrow.
How to install the batteries
Use micro batteries type UM-4 (R03/AAA-Size).
These batteries are offered as carbon / zinc-type or as alkaline-type. You may use both, but do not mix types. The
alkaline type lasts longer compared to the carbon / zinc type but is more expensive.
Note: Flat, weak batteries will leak. Corrosive electrolyte will damage the remote control handset.
Leak proof batteries will not leak immediately when they are flat. As long as the handset is still working, there is
no danger of leakage. To prevent damage, remove the batteries if you do not use the handset for several
months.
Damage because of leakage is not covered by the guarantee.
Distance of Remote
Control Operation
Effective angle:
approx. 60°
approx.
7m
Point the remote
control directly at the
remote sensor.
If bright sunlight
directly beams
onto the unit
front. If an obstacle is
placed between the
unit and the handset.
The remote control handset will not work properly in the following cases:
If the batteries have not
been installed according to
their polarities. If the batteries are
weak.
2J50101A [EN] P08-13 27/2/06, 5:38 PM 11