Toshiba M40 - Manual (Page 125)

3.11Error Codes and Description 3 Diagnostic Programs
EQUIUM M40/M45/Satellite M40/M45 Maintenance Manual 59
01
PCI bus Error during
device ID test
Don’t Scan PCI
device
Don’t support PCI BIOS
02
PCI Ethernet card not
present during device ID
test
Don’t find Net card Please insert Net cad
03
Intel PCI Ethernet card
not present during MAC
test Don’t found Net Card, This Card
can’t be Read MAC by this
method
Please update net card or use
other method
09xx Keyboard
01
Keyboard Map & Stroke
Test Fail Keyboard Map & Stroke Test
fails. Check the KBD connection and
repeat the test.
03 Clock Line Test Fail Clock Line Test fails. As above.
04 Data Line Test Fail Data Line Test fails. As above.
05xx Mouse
01 Touch Pad Test Fail Touch Pad Test Fail
Check the mouse connection and
repeat the test.
28xx 1394
01
Can not find IEEE1394
controller
Don’t support 1394.
20xx IDE-HDD
01 Get Parameter Fail !
Wrong test parameters are input
by user.
Reinput the correct parameters.
02 Write Pattern Error HD is damaged. Send the HD for repair.
03 Data Compare Error HD is damaged. As above.
04 Read Verify Error HD is damaged. As above.
05 Seek Error HD is damaged. As above.
06
Disk Controller Self Test
Failed
The HD controller is damaged. As above.
07
Disk Controller Test
unexpected interrupt
Failed
The HD controller is damaged. As above.
09
Disk Controller action
Test Failed
The HD controller is damaged. As above.
10
Disk dos not support
SMART
Disk dos not support SMART
Change HD which supported
SMART and test again
11
Disk read attribute
threshold error Disk read attribute threshold
error
Send the HD for repair.
12
Disk read attribute value
error
Disk read attribute value error As above.
13 Disk SMART attribute Disk SMART attribute value As above.