Toshiba Strata DK280 - Manual (Page 39)

Enter the desired
message number, or
00 if no message
should be stored.
6. Press the Redial
button to record the
data in memory.
Personal message (10 19) and system (60 99). The does not
display when setting a timed it displays when the reminder
Messages are set using the Record a Message method.
The LCD displays “DATA PROGRAMED”. You will hear a confirmation tone. The
message will be displayed at the specified time, and a beeping tone will be heard
for
30 seconds (or until it is canceled by pressing the Mode button and then
dialing
MESSAGE SENDING
The Alphanumeric Messaging feature on your LCD digital telephone enables you
to set short text (up to 32 characters) at your station to ensure that you do not
miss important calls. Any station may record a message; however, only stations
with the LCD are able to display messages. Stations that do not use Soft Keys
(Soft Keys Off: Mode 7 0) may send messages “live” to other LCD station users.
To record messages, see the Recording a Message section in this guide.
Your system has up to 40 preprogrammed messages that may be sent to other
LCD digital or electronic telephones. You can temporarily add to or change any
of these messages, in order to leave a personalized message at your station
(see Note below).
Some stations may record and save up to 10 personal messages to be used for
all types of station messaging. This is a station option that is enabled in system
programming.
To Set a Called Station
Message:
1. Dial the station number
(station does not
answer or is busy).
2. Press the Mode
button.
3. Dial 4.
4. Enter the desired
message number.
5. Press the
Msg button.
6. Press the Spkr button
to release.
CALLED STATION MESSAGING
Your station number and a message indication may be sent to another LCD
station. When that station responds, it will receive the message. Soft Keys must
be off (MODE 70) at the sending station for this feature to operate.
The LCD displays “MODE?”
The LCD displays “MW TO STNNN MSG NO?”
Personal message (10 system message (60 99). The LCD displays the
message.
“CALL NNNM” is displayed at the called station and the Msg LED flashes;
“SENT NNNM” is displayed at your station. N = Station Number, M indicates that
a message has been sent.
4-9