beautypg.com

Operations, Turning the power on and off – Toshiba Data TDP-T420 User Manual

Page 13

background image

4

5

Operations

Connecting the power cord

1

Insert the power cord connector

into the AC IN socket of the

projector.

2

Insert the power cord plug into a

wall or other power outlet.

Removing the lens cap

Be sure to remove the lens cap when the power is turned on. If the cap is left on the
projector, it could become deformed due to heat.

Turning the power on

1

Turn on the main power switch.

The ON/STANDBY indicator will change to orange,
indicating standby mode.

2

Press the ON/STANDBY button.

The power turns on with a beep sound (if the beep
sound is set to [

On]), and the ON/STANDBY indicator

lights green. After a moment, the start-up screen
appears.

CAUTION

Do not look into the lens while the lamp is on. The strong light from the lamp may cause

damage to your eyesight.

Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.

Do not place your hands, face, or other objects near the air exhaust, the lamp cover or

the bottom of the unit. Doing so could result in injury and/or damage the object.

Turning the power on and off

Operations

Notes

The start-up screen will disappear after a moment. You can dismiss the start-up screen
before this by performing any operation. You can also configure the system to prevent
the start-up screen from appearing. To do this, use the

Display setting menu

p.38

.

The first time you use the projector after purchase, after the start-up screen disappears,
the start menu is displayed

p.26

.

You can disable the beep sound in the

Default setting 1 menu

p.41

.

When [

Key lock] is [On], the operation buttons of the projector do not work

p.43

.

When [

Password] is [On], enter password then the start-up screen is displayed after the

Password entry screen disappears

p.33

.

Do not touch the lens directly with your hand.
If fingerprints or stains are left on the projection lens surface, they may interfere with the
projector’s ability to project images on the screen.

Turning the power off

1

Press the ON/STANDBY button.

A message appears on the screen, confirming that you wish to shut off the power.
To shut off the power, press the ON/STANDBY button again. If you do not wish to
shut off the power, wait for a while without conducting any operations. This message
will disappear after a moment. (This operation is no longer valid after the message
disappears.)

2

Press the ON/STANDBY button again.

When the setting of beep sound is [

On], the projector beeps, and the screen

disappears, but the internal cooling fan continues to operate. Then, the projector goes
into standby mode.
During cooling, the ON/STANDBY indicator flashes. While the
indicator is flashing, the power can not be turned back on. At this
point of time, it does not matter even if you unplug the power cord.

3

Turn off the main power switch.

4

Replace the lens cap.

After use, replace the lens cap.

Note

The projector consumes about 5W of power in standby.
We recommend that you unplug the power cord if you will not be using the projector for
an extended period.

Precaution

If the power cord is unplugged before cooling is complete or the main power is turned
off, give the lamp time (about 5 minutes) to cool before plugging it back in. If the lamp
overheats, it may fail to light.



Power cord connector

(Supplied)

Control panel

Remote

control