Tripp Lite B051-000 - Manual (Page 6)

IP Address Determination
IP Installer
If you are an administrator logging in for the first time, you need to access the B051-000 in
order to give it an IP address that users can connect to. There are three methods to choose
from; IP Installer, Browser or AP Windows Client. In each case, the computer you are
using to access the B051-000 must be on the same network segment as the unit. After you
have connected and logged in you can give the B051-000 its fixed network address.
Note: The default username is administrator and the default password is password. It is strongly recommended
that you change these upon accessing the unit for the first time.
For computers running Windows, an
IP address can be assigned with the IP
Installer utility:
1. Unzip the contents of IPInstaller.zip
(found on the CD that came with the
B051-000) and save them to a directory
on your hard drive.
2. Go to the directory and run the
IPInstaller.exe
. A dialog box similar to
the one below appears:
When the IP Installer main window comes
up, the utility scans the network for B051-
000 devices and lists the ones it finds in the
Device List Panel. The Device List Panel
consists of three columns, as shown in the
following table:
Item Description
Model Name The device’s model name (B051-000).
MAC Address The MAC address of the device.
IP Address The current IP Address of the device.
3. Select the B051-000 from the Device List.
• If there is more than one B051-000, use the MAC address to find the unit that you want.
The MAC address can be located on the bottom of the unit.
• If the list is empty, or the B051-000 does not appear, click Enumerate to refresh the
Device List.
Note: The Network Adapter drop-down list pertains to computers that have more than one network adapter
installed. Users should select the network adapter that they want the Enumerate signal to be sent to.
4. Once you have selected the desired B051-000, you must choose whether you want to
Obtain an IP address automatically (DHCP) or Specify an IP address
. If you choose
the latter, fill in the IP Address, Subnet Mask, and Gateway fields with the information
appropriate to your network.
5. Click Set IP.
6. Once the IP address shows up in the Device List, click Exit.
200909082 93-2851.indd 6 10/27/2009 3:41:21 PM