Tandberg Data VXA-320 (VXA-3) - Manual (Page 5)

O CTOBER 2006 VXA-320 T APE D RIVE
V
H
OW TO
U
SE
T
HIS
M
ANUAL
H
OW TO
U
SE
T
HIS
M
ANUAL
This manual describes how to install, operate, and maintain the VXA™-320
tape drive. It also provides functional, performance, and environmental
specifications.
O
RGANIZATION
The information in this manual is organized into chapters that allow you to
quickly locate the information you need.
First-time installation
If you are installing the tape drive for the first time, refer to the following
chapters:
Chapter 1 provides an overview of the tape drive’s features and
components.
Chapter 2 provides instructions for installing the tape drive, connecting it to
the host computer, and powering it on.
Operation, troubleshooting, maintenance, and service
Refer to these chapters for information about operating, maintaining, and
troubleshooting your tape drive:
Chapter 3 to learn how to load cartridges, clean the tape drive, and read the
LEDs.
Chapter 4 provides troubleshooting recommendations.
Chapter 5 provides information about service and maintenance for the tape
drive, including returning it for service, upgrading firmware, and obtaining
a diagnostic listing.
Specifications, standards, and terms
These chapters are for engineering, purchasing, or marketing personnel who
want to evaluate the tape drive to determine the feasibility of integrating it
into their product lines.
Chapter 6 provides an overview of the SCSI communication interface and
SCSI command protocol supported by the tape drive. It also describes the
communication interface specifications for the tape drive, including cable
and connector requirements for the LVD SCSI interface.
Chapter 7 provides specifications for the tape drive, including performance,
reliability, power, and environmental specifications. This chapter also
provides safety and regulatory agency standards compliance information.
The Glossary provides definitions of terms used in this book.