Pcmcia card recognition – Texas Instruments Adpater User Manual
Page 30
4.
Select DockMate as the Dock Type.
5.
Select OK.
You are prompted to reboot.
6.
Reboot and proceed to Reconfigure System Information.
Windows 95 starts configuring unknown hardware (this
may happen multiple times and is a standard operation
for Plug ’n Play in Windows 95).
Reconfigure System Information
The following steps allow you to reconfigure system
information for the Windows 95 Commercial Upgrade.
Checking Device Settings
1.
Go to the System icon located in the Control Panel.
2.
Select the Device Manager tab.
3.
Select Modem from the Device Manager tab.
4. Select
Resources after selecting the modem being used
and ensure that the modem is set to IRQ 3 and an
address 3e8.
5.
Select Resources after selecting PCMCIA socket and
verify that the PCMCIA socket is not turned off.
Remove Ports and Devices
1.
Go to the System icon located in the Control Panel.
2. Select Ports (COM & LPT) from the Device Manager tab.
3.
Select and remove all communications ports except
COM1.
4.
Select and remove all PCMCIA devices.
5.
Remove PCMCIA hardware devices from the TravelMate
notebook.
PCMCIA Card Recognition
Troubleshooting Procedures 4-7