Texas Instruments Adpater - Manual (Page 19)

Using TI Setup TI Setup is copied onto your system at the time you install
the DockMate Installation diskette. TI Setup is used to
configure peripheral hardware attached through your
DockMate. TI Setup is used in either Windows or Windows
95 environments.
To configure peripherals for use with your system, complete
the following steps:
1. Complete the following for your operating system:
❏
If you are using Windows 95 - Double-click on TI
Setup in the Control Panel
❏
If you are using Windows for Workgroups -
Double-click on TI Setup in the TravelMate
Notebook Center group
2. Select the tab labeled Ports-Dock A.
3. Under Dock Type, use the pulldown menu (by selecting
the ▼) and single-click on DockMate.
4. Using configuration information provided with your
peripheral device, change any required settings in this
window.
n
Note: A Ports-Dock B tab (identical to the Ports-Dock A
tab) is provided in case you have more than one type of
DockMate system and want to maintain settings for both
types. If both Ports Dock A and B are set to the same type
of DockMate system, only Ports Dock A settings are used.
The Ports - Undocked tab indicates settings for your
TravelMate notebook when undocked from the DockMate.
Using TI Setup
Utilities 3-3