Using ti setup – Texas Instruments Adpater User Manual
Page 20
The following table provides a synopsis of all options
available on the Ports-Dock A or Ports-Dock B tabs:
Item
Options
Description
Dock Type
None (default)
DockMate
DockMate Plus
DockMate Net Ready
DockMate
General Pn’P Dock
Allows you to select the
type of docking station
attached to your notebook.
General Pn’P Dock provides
auto setup for any
operating system that
supports true Plug ’N Play.
Dock 9 Pin
Off
COM1 (default)
COM2
COM3
COM4
Allows you to disable or set
the port address used for
the notebook or docking
system serial port.
Notebook SIR
Off
COM1 (default)
COM2
COM3
COM4
Allows you to disable or set
the port address used for
the docking system serial
infrared port.
Dock SIR
Off
COM1 (default)
COM2
COM3
COM4
Allows you to disable or set
the port address used for
the docking system port.
COM3/COM4
338h/238h
3e8h/2e8h (default)
2e8/2e0
Allows you to select the
address at which COM
ports 3 and 4 operate.
Dock Parallel Port Address
Off
3BCh
378h (default)
278h
Allows you to select the
address at which the
parallel port operates.
Dock Parallel Port
Extended Mode
Off (default)
SPP
EPP and SPP
ECP
ECP and EPP
Allows you to select the
protocol for bidirectional
operation (printers or
parallel network adapters).
Using TI Setup
3-4 Utilities