Texas Instruments Adpater - Manual (Page 29)

3. Double-click on the Ports (COM & LPT) option.
A list of selections appears.
4. Double-click on Communications Port (COM2).
The COM2 configuration is displayed.
5. Select the General tab.
6. Deselect Dock 1 (Current) located in the Device Usage
area.
7. Select OK/Close to close the Communications Port
Properties window.
8. Select OK/Close to close the System Properties
window.
9. Select the Start icon at the bottom of your screen.
10. Select Shutdown.
11. Select Restart the computer.
12. Select Yes.
The notebook restarts and the error should be cleared.
Windows 95 (Commercial Upgrade)
This version of Windows 95 is not TI-installed. If you are
running the Windows 95 commercial upgrade, these
instructions should clear PCMCIA Ethernet card problems.
Reconfigure TI Setup
1. Open the Windows Control Panel and select the TI
Setup icon.
2. Select the System Configuration tab and set the
parameter for PCMCIA I/O Addresses to Maximum.
3. Select the Dock A tab.
PCMCIA Card Recognition
4-6 Troubleshooting Procedures