Texas Instruments Adpater - Manual (Page 14)

DockM ate Hardware Install ati on
Docking the Notebook
Use the following procedure to dock your notebook
computer:
1. Clear an area on your workstation surface to permit
both units to be flat on the table or desktop while
performing the initial docking procedure.
2. Ensure that the rear port covers on the TM5000 are
open.
3. Lift the lever on top of the DockMate so that the guide
pin plate is extended.
4. Carefully match the holes on the underside of the
notebook with the guide pins protruding from the
DockMate and press down on the top lever to dock.
n Note: To undock the noteboook, lift up the lever and lift
the notebook off the docking pegs.
Inserting the notebook
DockMate Hardware Installation
DockMate Installation 2-5