Trane PTAC-SVX01C-EN User Manual
Packaged terminal air conditioner, Installation, operation, and maintenance
Table of contents
Document Outline
- Packaged Terminal Air Conditioner
- Table of Contents
- Model Number Description
- General Information
- Pre-Installation
- Unit Dimensions
- Electrical Requirements
- Installation Procedure
- Step 1. Remove rear closure panel from wall sleeve.
- Step 2. Install drain kit in wall sleeve.
- Step 3. Install outdoor air grille in wall sleeve.
- Step 4. Install wall sleeve in wall opening.
- 5. Install unit chassis in wall sleeve.
- Step 6. Install unit power supply.
- Step 7. Install the unit controls.
- Step 8. Configure the display module settings
- Field commissioning support
- Step 9. Programmable Settings
- Energy Management System
- Installation
- Sequence of Operation
- Automatic 3-minute Compressor Lockout
- Automatic 2nd Stage Electric Heat (PTHE only)
- Indoor Room Freeze Protection
- Random Restart Function
- Door Switch Occupancy Sensor
- Remote Thermostat Control
- Setpoint Limiting
- Active Defrost (PTHEs only)
- Remote Thermostat Operation
- Mode Button Operation
- Fan Operation
- Front Desk Control (FD1, FD2 Inputs)
- Remote Fan Operation
- Vent Control
- Air Discharge Grille
- Sequence of Operation
- Operation
- Maintenance Procedures
- Refrigeration System Service
- Brazing
- Evacuation
- Cooling Performance Test
- Ground Test
- Indoor Coil and Air Thermistors
- Outdoor Coil and Air Thermistors
- Heater Assembly with Power OFF to the Unit and Heater
- Reversing Valve
- Component Replacement
- Temperature-Actuated Drain Valve (model PTHE Only)
- Unit Disassembly Procedures
- Power Cord Removal
- Power cord Installation
- Capacitor Removal
- Heater Assembly Removal
- Removing the Indoor Coil and Indoor Air Thermistors
- Removing the Outdoor Coil and Outdoor Air Thermistors
- Indoor Fan and Motor
- Outdoor Fan and Motor
- Control Board Replacement Procedure
- Maintenance
- Troubleshooting
- Wiring Diagram
- Warranty