Toshiba e-STUDIO382p - Manual (Page 15)

Windows > 15
M
ANUALLY CONFIGURING THE
IP
ADDRESS
If there is no DHCP protocol to automatically assign IP addresses to devices on your
network, you might want to set the IP Address, Subnet Mask and Default Gateway Address
for your printer manually.
1.
In the “Network Card Setup” pane, click to select the printer.
2. Select Setting > Setting Printer. The Printer Settings dialog displays.
3. Select Manual. In the Details section, you can now edit the IP Address, Subnet
Mask and Default Gateway Address.
4. Click OK. The “Admin Password Required” dialog displays.
5. Enter the password. The default password is the last six digits of the MAC address.
6. Click OK. Allow a few seconds for the changes to save and the printer to
automatically restart before the “Setup Completed” message box appears.
C
HANGING THE ADMIN PASSWORD
To change the Admin Password for your printer:
1.
Select Setting > Change Password.
2. Enter and verify the new password as requested.
3. Click OK. Allow a few seconds as the settings are saved and the printer
automatically restarts.
E
NABLE
/
DISABLE THE PRINTER WEB PAGE
To enable/disable access to the Printer Web Page from the Network Card Setup utility:
1.
Select Setting > Setting Printer.
2. Select the “Printer Web Page” tab and select Printer Web Page - Enable or
Printer Web Page - Disable.
3. Click OK. The “Admin Password Required” dialog box displays.
4. Enter the admin password as requested and click OK.
5. The “Setup Completed” message is displayed.
6. Restart the printer.
If you disabled the web page setting and you now try to view the Printer Web Page, an error
message is displayed.
NOTE
If your printer stops at any time, you can restart it by selecting Setting >
Restart Printer in the “Network Card Setup pane”.