Tally Genicom mL450 - Manual (Page 144)

Publication No. GEG-99197 May 04
6-2 TallyGenicom mL450 Laser Printer User Manual
Solving Printer Power-on Problems
About this Chapter
Explains procedures to isolate and solve problems that may occur during use of your printer. Clear-
ing paper jams and detailed troubleshooting of LCD error messages are discussed in this chapter.
Solving Printer Power-on Problems
This section describes problems that can occur when starting up the printer. If the trouble persists
after performing the checks listed below, turn the printer off [ O ], disconnect the power cord from
the AC outlet, and call to arrange for a technical support or service or repair call.
CAUTION: To prevent the risk of fire or smoke generation, do not attempt to modify the
printer in any way.
WARNING: Before cleaning the printer or performing any other maintenance, be sure to
turn the printer off [ O ], and disconnect the power cord from the AC outlet to prevent the
risk of electric shock.
DESCRIPTION POSSIBLE
CAUSE
REQUIRED
ACTION
No power. Power switch not turned on.
Switch not set to [ I ]. Check power switch. See
”Chapter 1 Unpacking and
Installing Your Printer”
for
Printer” for more information
Power cord not properly
plugged into AC outlet or AC
connector on rear of printer Set power switch to [ O ]
(off) and plug in power cord
firmly. See
”Chapter 1
Unpacking and Installing
Your Printer”
for more
information.
Voltage of AC power line not
correct. Verify that AC outlet is rated
for the correct voltage and
amperage of your printer.
See
”Chapter 1 Unpacking
and Installing Your Printer”
for more information.
Power is frequently
interrupted Printer is defective Turn printer off [ O ],
disconnect power cord from
the AC outlet. Call to arrange
for a technical support or
service or repair call.