Toshiba Strata DK8 - Manual (Page 317)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-67-
TABLE RM-BU
CO LINE TEST
ACTION STEP DISPLAY/PRINTOUT
1 >MODE TEST Enter the Test Mode
At the >MODE prompt, enter
T E S T CR .
2 T SEKT XX IDLE ON-HOOK
T
T SCO YY IDLE
To Verify Station/CO Line Status
3 Call Remote Station B
Enter
T K X X K Y Y CR .
( = station B’s telephone number)
Answer station B.
4 A)
B)
C)
T TK XX KYY
T
T TKXX H
T
NOTE:
If the system is equipped with Music-on-hold, go to step 4. If the
line must be tested via a CO-to-CO connection, go to step 6.
Station line status, enter S E K T X X X X
CO line status, enter S C O Y Y Y Y
= station port).
= CO line number).
(from SEKT XX and CO line YY)
Press the Hold button on TK XX (station B on hold).
Enter T K X X H CR .
Listen at station B and check that the transmission from the
music source is acceptable.
Press the
Spkr button on TKXX (to release the call).
Enter T K X X S CR .
5 Continue returning to step 2 until all CO lines are tested.
6 To Set Up A CO-to-CO Connection
Press the Cnf/Trn button on T K X X .
NOTES:
1.
2.
3.
Station B is connected via step 3.
Verify that
The next step must be completed immediately to avoid
dial tone timeout.
T TKXX S
T
T TKXX C
T
7 Call station C (or local time/weather) via CO line C.
Enter:
T K X X K Y Y CR .
X X = CO line C’s button number and = telephone number of
station C.
Answer station C (or verify time/weather connection) and go to
next step.
T TKXX KYY
T
8 Press the Cnf/Trn button on STXX to establish a conference
between all parties.
9 If you wish to tie the two CO lines together and hang up:
Enter
T K X X C CR .
T TKXX C
T
T TKXX C
TTKXX S
T
10 Continue returning to step 2 until all CO lines are tested.
11 To Exit the Test Mode,
At the T prompt, enter
Q U I T CR .
(
(
Enter T K X X C CR .
Program 15-5 allows CO-to-CO connections.
Enter T K X X S CR .