Toshiba Strata DK8 - Manual (Page 265)

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
SECTION 100-816-600
MARCH 1993
-15-
IMPORTANT NOTE:
For DK16 only: If all programs are initialized, the "IMDU enabled" has also been turned off in
Program 77-1
, LED 14. If using the IMDU for remote programming, go into Program 77-1 and turn
button/LED 14 on as shown in steps 9, 10, and 11. If this is not completed, remote programming
must be reactivated locally from the programming digital or electronic telephone.
TABLE RM-D
PROGRAM 90
INITIALIZING PROGRAMS 00 ~ 97
ACTION STEP DISPLAY/PRINTOUT
1 >MODE PROG Enter the Program Mode
At the >MODE prompt enter
P R O G CR .
2 P 90
P90
Enter Program Number 90
Press
CR .
3 P90 00 * 97 To Initialize All Programs Enter 0 0 * 9 7
NOTE: Single programs can be initialized by entering a single
program number plus
# . Group numbers are separated by an * .
4 P90 00 * 97 01 N Enter button/LED number 0 1 .
5 P90 00 * 97 01 N Y Change 01 button/LED to “ON” by entering Y .
7
8 Press CR .
Press SPACE . 6
P90 00 * 97 01 N Y
02 N Y
Initialization complete.
P90 00 * 97 01 N
P90
02 N Y
P90 00 * 97 01 N Y
02 N
9
10
11
12
Exit Program 90
Press
# # CR .
P90 #
P
For DK16, Enter Program 77
Press
7 7 CR .
P77
then: Y CR .
Press 1 1 4 . P77 1 14 N
P77 1 14 N Y
P77
To Exit this Program:
Press # # CR .
NOTE: If program data is not entered correctly, then CR will
not respond. To retry, press DELETE CR .
Change LED 02 to “ON” by entering Y .