Transition Networks POINTSYSTEM CPSMC0810-100 - Manual (Page 8)

8
CPSMC08xx-100 PointSystem ™ Chassis
slide-in-modules
24 hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
2.2.4 Replacing the Media Converter Slide-in-Modules
CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when replacing media converter slide-in-module(s). Failure to observe
this caution could result in damage to, and subsequent failure of, the media
converter slide-in-module(s).
NOTE: The media converter slide-in-modules can be hot-swapped.
To replace a media converter slide-in-module:
1. Remove the slide-in-module to be replaced by loosening the panel fastener
screw that secures the module to the chassis front. Slide the module from the
chassis.
2. Align the replacement slide-in-module with the chassis installation slot so that
the panel fastener screw is to the left.
3. Carefully slide the replacement slide-in-module into the installation slot, while
aligning the module’s circuit board with the installation guides.
NOTE: Ensure that the slide-in-module is firmly seated inside the chassis.
4. Push in and rotate the attached panel fastener screw clockwise to secure the
slide-in-module to the chassis.
RX TX
LNK PWR RESET
DB-9
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX LKS
PWR
LKM Multimode Singlemode TX RX TX RX
CFETF1
10
SPD
PWR
FRX CRX
FLNK CLNK
10/100TX RX TX 10/100SX CPSMC-0800
8-Slot Chassis
Mpls, MN 55344 Mpls, MN 55344
Input Power: Input Power:
110-240 VAC 110-240 VAC
1.6A max. (60W max) 1.6A max. (60W max)
50/60 Hz 50/60 Hz
LKS
PWR
LKM Multimode Singlemode TX RX TX RX
Panel Fastener Screw