Transition Networks POINTSYSTEM CPSMC0810-100 - Manual (Page 25)

25
CPSMC08xx-100 PointSystem ™ Chassis
24 hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
Technical Specifications
For use with Transition Networks Model CPSMC08xx-100 or equivalent.
Dimensions 17 x 10.4 x 1.8 inches (432 x 264 x 46 mm)
Shipping Weight 8 lbs. (3.6 kg)
AC Power Supply
Power Input: 100-240 V, 50/60 Hz, 0.66-1.6 Amp (typical with a fully-loaded chassis)
Power Output: +12 VDC at 5 Amp maximum.
DC Power Supply
Power Input: 48-VDC (38 to 58 VDC) @ 1.6 Amp (typical with a fully-loaded chassis)
Power Output: +12 VDC at 8.3 Amp maximum.
MTBF (Mean Time Before Failure) MIL217F2 V5.0 (hrs) Bellcore7 V5.0 (hrs)
without fans 43,277 114,896
with three (3) fans 22,972 61,715
Environment
Tmra: 0 to 40°C (32° to 104°F ) (Manufacturer’s rated ambient temperature)
Storage Temperature: -40 to 80°C (-40 to 176°F )
Humidity: 5 to 95%, non condensing
Altitude: 0 to 10,000 feet
Compliance EN 55022 Class A; EN 55024; FCC Class A; CE Mark
Warranty Lifetime
Product is certified by the manufacturer to comply with DHHS Rule 21/CFR, Subchapter J applicable at the
date of manufacture.
The fiber optic transmitters on this device meets Class I Laser safety requirements per IEC-825/CDRH
standards and complies with 21 CFR1040.10 and 21CFR1040.11.
CAUTION: Visible and Invisible Laser Radiation When Open. Do Not Stare Into Beam Or View Directly
With Optical Instruments.
CAUTION: Use of controls, adjustments or the performance of procedures other than those specified herein
may result in hazardous radiation exposure.
Declaration of Conformity
Name of Mfg: Transition Networks
6475 City West Parkway, Minneapolis MN 55344 USA
Model: 8-Slot PointSystem ™ Chassis
Part Number: CPSMC0800-100, CPSMC0810-100
Regulation: EMC Directive 89/336/EEC
Purpose: To declare that the 8-Slot PointSystem ™ Chassis to which this declaration
refers is in conformity with the following standards.
EN 55022:1994; EN 55024:1998; FCC Part 15 Class A; 21 CFR subpart J
I, the undersigned, hereby declare that the equipment specified above conforms to the above
Directive(s) and Standard(s).
_April 1, 2003_____
Stephen Anderson, Vice-President of Engineering Date