Slide-in-modules, 2 installing the management modules, Chassis – Transition Networks POINTSYSTEM CPSMC0810-100 User Manual

Page 10: Panel fastener screw

CPSMC08xx-100 PointSystem

™

Chassis

slide-in-modules

24 hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600

2.2.2

Installing the Management Modules

CAUTION: Wear a grounding device and observe electrostatic discharge
precautions when installing the management module(s) in the CPSMC08xx-100
chassis. Failure to observe this caution could result in damage to, and subsequent
failure of, the management module.

NOTE: Transition Networks recommends installing the management module into
the left-most installation slots to keep the management cables separate from the
media converter cables.

To install a management module into the CPSMC08xx-100 chassis:

1a. CPSMM-200 Dual-Slot Master Management Module:

If chassis face plates are covering the installation slots, remove two (2)
management module protective plates from the two (2) installation slots at the
far-left position of the chassis.

1b. CPSMM-120 Single-Slot Master Management Module OR

CPSMM-210 Single-Slot Expansion Management Module:
If chassis face plates are covering the installation slots, remove one (1)
management module protective plate from one (1) installation slot at the far-left
position of the chassis.

2. Align the management module with the PointSystem™ chassis installation slot

so that the panel fastener screw is to the left of the module.

3. Carefully slide the management module into the installation slot, while aligning

the module’s circuit board with the installation guides.

NOTE: Ensure that management module is firmly seated inside the chassis.

4. e the attached panel fastener screw clockwise to secure the module to the

chassis.

PWR

CPSMC-0800
8-Slot Chassis

Mpls, MN 55344

Input Power:

Input Power:
110-240 VAC

110-240 VAC
1.6A max. (60W max)

1.6A max. (60W max)
50/60 Hz

50/60 Hz

LNK

PWR

RESET

DB-9

Panel Fastener Screw