Transition Networks POINTSYSTEM CPSMC0810-100 - Manual (Page 12)

12
CPSMC08xx-100 PointSystem ™ Chassis
po
wer supply
3 Powering the CPSMC08xx-100
The CPSMC08xx-100 chassis can be powered through an AC or DC power supply.
An optional auxiliary power supply, with instant fail over protection, is also
available.
NOTE: The CPSMC08xx-100 chassis does not have an ON/OFF switch.
• Power up the chassis by connecting the power supply.
• Power-down the chassis by disconnecting power supply.
NOTE: Contact Technical Support for any questions concerning power supply.
3.1 Primary Power Supply
3.1.1 AC Power Supply
The CPSMC0800-100 includes an internal AC power supply, which is accessed
through a power inlet on the front panel. The power cord is included.
To power the CPSMM0800-100 chassis through the primary AC power supply:
1. Connect the female end of the power cord to the power inlet on the front panel
of the chassis.
2. Plug the male end of the power cord into the correct voltage rack or wall socket.
3. Verify that the chassis is powered by observing the illuminated power LEDs on
the installed slide-in-modules and by the chassis’ fan operation.
24 hour Technical Support: 1-800-260-1312 -- International: 00-1-952-941-7600
CPSMC-0800
8-Slot Chassis
Mpls, MN 55344 Mpls, MN 55344
Input Power: Input Power:
110-240 VAC 110-240 VAC
1.6A max. (60W max) 1.6A max. (60W max)
50/60 Hz 50/60 Hz
Power Inlet
Power Cord