Telenetics OM-AMPS-100 User Manual
Page 56
Appendix A
8-Port Expansion Module Option
56 OMEGA Installation, Operation, and Maintenance Manual
3.
Insert the cable clip into the round hole next to the relays
labeled K2 and K3 on the component side of the Module. Use
this cable clip to route and arrange cables within the OMEGA
unit.
4.
Hold the Module vertically above the card guides, so its 8 RJ-
11 jacks are at the top and facing toward the inside of
OMEGA.
5.
Insert the Module into the card guide slots and slide it down
until the male connector engages fully into the female
connector on the OMEGA baseboard (see Figure A-1). This
installation can only be made one way. If you are not
successful with your first try, turn around the Module and try
again.
Firgure A-1. Sliding the Module into the Card Guides