Telenetics OM-AMPS-100 - Manual (Page 16)

Section 1 Contents
16 OMEGA Installation, Operation, and Maintenance Manual
Required Materials and Tools
You need the following materials to install the OMEGA unit:
c
Either screws or bolts to attach OMEGA to a mounting surface.
c
Washers to fit with the screws or bolts.
c
A ¾-inch plywood backplate if the mounting surface is dry
wall.
Have the following tools available for installing the OMEGA unit:
c
Appropriate tools for the hardware you are using to mount the
unit (for example, a screwdriver and wrench).
c
Flex–type conduit if you are installing the unit outside.
c
Optional: a telephone handset.
In addition to the tools above, the OMEGA cellular phone must be
activated, either by Telenetics or a cellular service provider. If
Telenetics does not activate the OMEGA cellular phone, use the
supplied OMEGA configuration program or the optional
OmegaMate to configure the phone’s electronic serial number
(ESN) and phone number.
Mounting OMEGA
Mount and secure OMEGA to a wall or panel using the supplied
fasteners (see Figure 1-2). Any additional hardware required to
mount OMEGA on a wall or panel must be user-supplied.
NOTE: Your OMEGA may look different than the one in Figure 1-2.