Telenetics OM-AMPS-100 - Manual (Page 44)

Section 4
Using the Configuration Program
44 OMEGA Installation, Operation, and Maintenance Manual
3. Type the new password. The password can contain up to eight
alpha and/or numeric characters. If you type fewer than eight
characters, press Enter. The configuration program prompts
you to re-enter the new password you typed.
NOTE: For security purposes, each password character you type appears as
an asterisk (*).
4. Re-enter the same password you typed in the previous step and
press Enter. The message Updating password… appears
followed by Password updated.
After you change the password, you will need to specify it before
you can log in to the OMEGA configuration program. To return to
the default setting of no password, repeat this procedure but press
the Enter key in steps 3 and 4 without typing any characters.
NOTE: If the password you type in step 4 is different than the one you
typed in step 4, the message Password mismatch appears and the
new password does not take effect. If this happens, repeat this
procedure, making sure to type the same characters in steps 3 and 4.
Exiting the Configuration Program
To exit the OMEGA configuration program:
1. From the secondary menu, press Q at the ? prompt. The
message Please wait… appears followed by the Main Menu.
2. At the ? prompt, press Q again. You exit the OMEGA
configuration program and return to an MS-DOS prompt.
3. If your computer is running a Windows operating system, you
can close the MS-DOS window by typing exit and pressing
Enter.