Telenetics OM-AMPS-100 - Manual (Page 42)

Section 4
Using the Configuration Program
42 OMEGA Installation, Operation, and Maintenance Manual
Figure 4-3. Example of Signal Bar
2. To exit this mode and return to the Main Menu, press the Esc
key.
Programming a Telephone Number
Use the following procedure to program a telephone number into
the OMEGA’s cellular telephone.
1. From the Main Menu in Figure 4-2, press 2. The message
Waiting for response… appears, then the configuration
program prompts you for a password (see Figure 4-4).
Figure 4-4. Password Prompt
2. Type the password and press Enter. Initially, there is no
password, so press Enter without typing any characters. The
message Checking password… appears followed by the
secondary menu (see Figure 4-5).
Figure 4-5. Secondary Menu
3. At the ? prompt, press 2. The configuration program prompts
you for a new telephone number.
4. Type the 10-digit telephone number (area code and telephone
number). You do not have to press Enter after typing. The
message Updating phone number… appears followed by
Phone number updated! Then the secondary menu reappears
with the new telephone number displayed.