TurboChef Technologies Tornado - Manual (Page 16)

6 ASSEMBLY AND INSTALLATION
5. Remove the legs of the oven that will be placed
on top. This requires two or more persons—at
least one person to lift and one person to
unscrew the legs.
6. Remove the screws from the oven that will be
placed on top, as marked with black arrows in
Figure 4.
7. Place the oven on top of the oven that has the
stacking bracket attached.
WARNING: Do not attempt to lift the oven
with fewer than 2 people.
WARNING: When lifting the oven, position
at least one person on each side. Do not lift
the oven from the front and back, and do not
use the handle to lift the oven.
8. Align the holes on the Stacking Bracket with the
holes on the top oven and reinstall the screws.
WARNING: Do not stack ovens over two-
high.
Built-In Installation (Figure 5)
TurboChef ovens are designed to be installed on a
countertop or table. They are not intended for
built-in or enclosed installation.
“Built-in or enclosed installation” is defined as
installing an oven in any structure that surrounds
the oven by five sides (i.e., top/rear/side panels and
base).
If installation must be “built in,” the operator
must ensure the following:
†
Minimum of 300 cfm (8.5 cmm) of supplement
flow within the cabinet.
†
Minimum clearances of 2" (51 mm) to every
surface.
In addition, the operator will be responsible for
compensating any extra time required to service
the product due to removing the product for
serviceability.
Installation Near Open Heat Source (Figure 6)
When placing a TurboChef oven near an open
heat source, strictly adhere to the following:
†
Verify oven location has a minimum 6" (152
mm) clearance on top and minimum 2" (51
mm) of clearance on each side.
†
If the oven is being placed near a grill or stove,
there must be a divider between the oven and
the open heat source, with a minimum of 6"
(152 mm) between the oven and the divider.
†
If the oven is being placed near a fryer, there
must be a divider between the oven and fryer,
with a minimum of 12" (305 mm) between the
oven and the divider.
†
The height of the divider must be greater than
or equal to the height of the oven (23"/584
mm).
Ventilation Requirements
The TurboChef Tornado TM oven has been tested
by Underwriters Laboratory which has concluded
that this oven can be installed and operated ventless
for all food items except for fatty raw proteins, such
as bone-in, skin-on chicken, uncooked hamburger,
fat-laden steaks, etc.
NOTE : In no event shall the manufacturer assume
any liability for damages or injuries resulting from
installations which are not in compliance with the
instructions and codes previously listed.
OVEN ASSEMBLY
Oven Assembly
1. Carefully remove packing materials from the
wire rack.
2. Open the cook cavity door.
3. Remove packing materials from inside the oven.
4. Place wire rack in oven.