Toshiba TDP-P75 - Manual (Page 27)

Operation 27
English
Adjusting the image
Adjusting the height
The projector is equipped with 1 quick-release adjuster foot and 1 tilt adjuster
foot. The adjusters can be used to change the image height and projection angle.
To adjust the projector to your desired
image height and projection angle:
1.
Lift the projector up to the desired
angle and press the front adjuster
button to release the adjuster. The
adjuster will drop into position.
2. Screw the tilt adjuster foot to fine
tune the horizontal angle.
To retract the feet, hold up the projector
while pressing the front adjuster button,
then slowly lower the projector. Screw the rear adjuster foot in a reverse direction.
If the screen and the projector are not perpendicular to each other, the projected
image becomes vertically trapezoidal. To correct this situation, adjust the value of
Keystone in the Picture menu, on the projector control panel or on the remote
control.
Auto-adjusting the image
In some cases, you may need to optimize the picture
quality. To do this, press the AUTO button on the
control panel of the projector or on the remote control.
Within 5 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of
Frequency, and Clock to provide the best picture
quality.
This function is only available when the Computer input
is selected.
The screen will be blank while the auto-adjustment is
functioning.
Fine-tuning the image size and clarity
2
1
1. Adjust the projected image to
the size that you need using the
zoom ring. 2. Then sharpen the image by
rotating the focus ring.