Toshiba TDP-P75 - Manual (Page 19)

Overview 19
English
Preparing and using the remote control
Dry-cell batteries
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the
batteries with new ones.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed
to bright sunlight or fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote
control. If this happens, point the remote control at the main unit again, and
repeat the operation.
Q Loading dry-cell batteries into
the remote control
1. Remove the battery cover.
2. Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
3. Replace the battery cover.
Q Operating the remote control
Point the remote control toward the
projectorfs infrared remote sensor, and
press a button on the remote control.
• Operating the projector from the front
• Operating the projector from the rear
(2)
(1)
IN PU T
Approx. 15°
A
pp
ro
x.
5 m
INP UT
Approx. 15°
Ap
pro
x. 5
m