Onkyo TX-NR515 - Manual (Page 72)

Controlling Other Components
En-72
Onkyo components that are connected via are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
Controlling Onkyo components without
If you want to control an Onkyo component by pointing the
remote controller directly at it, or you want to control an
Onkyo component that’s not connected via
, use the
following remote control codes:
` 30627:
Onkyo DVD player without
` 71817:
Onkyo CD player without
` 32900/33100/33500:
Onkyo Blu-ray Disc player
` 32901/33104/33504:
Onkyo HD DVD player
` 70868:
Onkyo MD recorder without
` 71323:
Onkyo CD recorder without
` 82990:
Onkyo Dock without
You can reset a REMOTE MODE button to its default
remote control code.
You can reset the remote controller to its default settings.
Remote Control Codes for Onkyo
Components Connected via
1 Make sure the Onkyo component is connected with
an
cable and an analog audio cable (RCA).
See “Connecting Onkyo Components” for details
( ➔ page 18 ).
2 Enter the appropriate remote control code for a
REMOTE MODE button, by referring to the
previous section.
` 42157:
Onkyo cassette tape deck with
` 81993:
Onkyo Dock with
3 Press the REMOTE MODE button, point the
remote controller at the AV receiver, and operate
the component.
Resetting the REMOTE MODE Buttons
1 While holding down the REMOTE MODE button
that you want to reset, press and hold down HOME
until the remote indicator lights (about 3 seconds).
2 Within 30 seconds, press the REMOTE MODE
button again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each REMOTE MODE button is preprogrammed
with a remote control code. When a button is reset, its
preprogrammed code is restored.
Resetting the Remote Controller
1 While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.