Source setup, Audyssey, See “audyssey” in “source setup – Onkyo TX-NR515 User Manual
Page 55: Setup, En-55
Advanced Operations
En-55
■
TrueHD Loudness Management
`
Off
`
On
This setting specifies whether or not to apply the Late
Night processing on a Dolby TrueHD source.
Note
• When this setting is set to “Off”, the Late Night function for
Dolby TrueHD sources is automatically fixed to “Off”.
DTS
■
Neo:6 Music
Center Image
`
0 to 2 to 5
The DTS Neo:6 Music listening mode creates 6-channel
surround sound from 2-channel stereo sources. With this
setting, you can specify by how much the front left and
right channel output is attenuated in order to create the
center channel.
Changing the value from “0” to “5” will spread the sound
of the center channel to left and right (outwards).
Theater-Dimensional
■
Listening Angle
`
Wide:
Select if the listening angle is 40 degrees.
`
Narrow:
Select if the listening angle is 20 degrees.
With this setting, you can optimize the Theater-
Dimensional listening mode by specifying the angle of the
front left and right speakers relative to the listening
position. Ideally, the front left and right speakers should be
equidistant from the listening position and at an angle close
to one of the two available settings.
Items can be set individually for each input selector.
Main menu
Source Setup
Audyssey
■
Audyssey
`
Off
`
Movie:
Select this setting for movie material.
The Audyssey indicator will light.
`
Music:
Select this setting for music material.
The Audyssey indicator will light.
Note
• When “Audyssey Quick Start” has been used for measurement,
“Audyssey” cannot be selected.
• Audyssey equalizing does not work with DSD sources.
20°/40°
Front left speaker
Front right speaker
Source Setup
Preparation
Press the input selector buttons to select an input source.
The tone for each speaker is set automatically by
Audyssey 2EQ
®
Room Correction and Speaker Setup.
To enable the following settings, you must first perform
the Room Correction and Speaker Setup (
• These technologies cannot be used when:
– a pair of headphones is connected, or
– either Pure Audio (European, Australian and Asian
models) or Direct listening mode is selected.
1 2 3 4
5
“Setup”