Onkyo TX-NR515 - Manual (Page 18)

Connections
En-18
With (Remote Interactive), you can use the following
special functions:
■ System On/Auto Power On
When you start playback on a component connected via
, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
■ Direct Change
When playback is started on a component connected via
, the AV receiver automatically selects that
component as the input source.
■ Remote Control
You can use the AV receiver’s remote controller to
control your other
-capable Onkyo components,
pointing the remote controller at the AV receiver’s
remote control sensor instead of the component. You
must enter the appropriate remote control code first
(
➔ page 72 ).
Note
• Use only cables for connections. cables are supplied
with Onkyo components.
• Some components have two jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional -capable components.
• Connect only Onkyo components to jacks. Connecting other
manufacturer’s components may cause a malfunction.
• Some components may not support all functions. Refer to the
manuals supplied with your Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change functions do not work.
Connecting Onkyo Components
1 Make sure that each Onkyo component is connected
with an analog audio cable (connection in the
hookup examples) (
➔ page 17 ).
2 Make the connection (see the illustration).
3 If you’re using an RI Dock, or cassette tape deck,
change the Input Display (
➔ page 43 ).
L R
ANALOG
AUDIO OUT
L R
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock