Onkyo TX-NR515 - Manual (Page 46)

Advanced Operations
En-46
Note
• When the “Monitor Out” setting is set to “Sub”, “Video” cannot
be selected.
*1 • The video preview is not displayed when:
– HDMI IN 5/6/7 is the current HDMI input source, or
– No signal is present on the current input source.
*2 Only when you have selected “Custom” in the “Picture
Mode” (
➔ page 58 ), pressing ENTER allows you to adjust
the following items via the Quick Setup: “Brightness”,
“Contrast”, “Hue” and “Saturation”. Press RETURN to
return to the “Picture Mode” setting.
*3 Depending on the input source and listening mode, not all
channels shown here output the sound.
*4 • This setting is not available in either of the following cases:
– The “Audio TV Out” setting is set to “On” ( ➔ page 62 ).
– “HDMI Control(RIHD)” is set to “On” ( ➔ page 62 ) and
you’re listening through your TV speakers.
You can change various audio settings from the Quick
Setup (
➔ page 45 ).
Note
• These settings are not available in either of the following cases:
– The “Audio TV Out” setting is set to “On” ( ➔ page 62 ).
– “HDMI Control(RIHD)” is set to “On” ( ➔ page 62 ) and
you’re listening through your TV speakers.
Tone Control
■ Bass
` –10dB to 0dB to +10dB in 2 dB steps
You can boost or cut low-frequency sounds output
from the front speakers.
■ Treble
` –10dB to 0dB to +10dB in 2 dB steps
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when Direct or Pure Audio (European, Australian
and Asian models) listening mode is selected.
Operating on the AV receiver
Speaker Levels
■ Subwoofer Level
` –15dB to 0dB to +12dB in 1 dB steps
■ Center Level
` –12dB to 0dB to +12dB in 1 dB steps
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to “Level Calibration” (
➔ page 53 ) before
setting the AV receiver to standby.
Note
• You cannot use these function while the AV receiver is muted.
• These settings cannot be used while a pair of headphones is
connected.
• Speakers that are set to “No” or “None” in
“Speaker Configuration” ( ➔ page 52 ) cannot be adjusted.
Audyssey
■ Audyssey
See “Audyssey” in “Source Setup” ( ➔ page 55 ).
■ Dynamic EQ
See “Dynamic EQ” in “Source Setup” ( ➔ page 56 ).
■ Dynamic Volume
See “Dynamic Volume” in “Source Setup” ( ➔ page 56 ).
Note
• These technologies can be used when all the following conditions
are met:
– Room Correction and Speaker Setup is completed. Note that
“Audyssey” requires the “Audyssey 2EQ Full Calibration”
method.
– Any listening mode other than Direct or Pure Audio
(European, Australian and Asian models) is selected.
– A pair of headphones is not connected.
• The setting is stored individually for each input selector.
Using the Audio Settings of Quick
Setup
1 Press TONE repeatedly to select either “Bass” or
“Treble”.
2 Use – and + to adjust.