Removing front cover, Installation – Outback Power Systems GS8048 User Manual

Page 23

Text mode
Original mode

Installation

900-0021-01-00 Rev A

Removing Front Cover

The front cover must be removed in order to access the Radian inverter’s AC terminals and other
connections. These include the “Remote” and “Batt Temp” ports, as well as several sets of auxiliary
terminals.

Twenty-two machine screws are located around the perimeter. Remove these screws with a Phillips
screwdriver. Once they are removed, the cover can be lifted off.

Figure 10 Cover Screws

NOTE:

The Radian inverter may ship with only a few screws installed, to make it easier to perform the

initial installation. If this is done, the remaining screws will be included in the hardware kit.

Screws