Outback Power Systems GS8048 - Manual (Page 13)

900-0021-01-00 Rev A 11
Introduction
Welcome to OutBack Power Technologies
Thank you for purchasing the OutBack Radian Series Inverter/Charger. This product offers a complete
power conversion system between batteries and AC power. It can provide backup power, sell power
back to the utility grid, or provide complete stand-alone off-grid service.
Figure 1 GS8048 Inverter/Charger
IMPORTANT:
This product is not compatible with the OutBack MATE or MATE2 System Display and
Controller. Use of these products is not supported with the Radian Series.
Mounts easily with supplied mounting plate.
All terminals exit at the bottom of the inverter.
This allows the installer to use a single distribution
box. The GS Load Center (GSLC) is specifically
designed for this purpose and is sold separately.
Uses spring-based AC terminals instead of
screw-based terminals. This eliminates torque
requirements and periodic re-tightening.
Uses the MATE3 System Display and Controller
(sold separately) for user interface.
Features versatile mounting locations for the
MATE3, HUB, and FLEXmax products, as well as
the GSLC.
The venting on the cover allows mounting of
multiple Radian inverter/chargers side by side
with zero clearance required between them.
Up to 10 Radian Series Inverter/Chargers can be
stacked together.