Sylvania NB500SL9 - Manual (Page 32)

30 EN
SPECIAL SETTINGS
Setting the BD Audio Mode
There are 2 ways to set “BD Audio Mode” setting;
whether to output the secondary and interactive audio
accompanied by the primary audio or only the primary
audio. Depending on the setting of the mode, Dolby
Digital, Dolby Digital Plus, Dolby TrueHD, DTS, or DTS-HD
output changes between multi LPCM and bitstream.
1 In stop mode with BD inserted, press
[MODE].
2
Use [K / L] to select your desired setting.
BD Audio Mode Mix Audio Output
“Mix Audio Output”:
If it is available, BD-video’s secondary and interactive
audio will be output with the primary audio.
The secondary audio is the audio for the secondary
video (Director’s comment etc.) and the interactive
audio is the audio for the interactive application
(Button click sounds etc.).
“HD Audio Output”:
Only the primary audio will be output. Set this mode in
order to output Dolby Digital, Dolby Digital Plus, Dolby
TrueHD, DTS or DTS-HD audio of BD through HDMI
connection.
3 Press [RETURN ] to exit.
You can also set “BD Audio Mode” from the setup
menu. Refer to page 36.
Note
In “Mix Audio Output” mode, if there is no secondary
and interactive audio, the audio will be output as
“HD Audio Output” mode.
In “Mix Audio Output” mode, even if you set “HDMI
Multi(Normal)” in “HDMI Audio Out” setting, multi
LPCM will be output from HDMI OUT jack for BD
audio. Refer to page 14.
In “Mix Audio Output” mode with HDMI audio being
output, 2-channel down-mixed LPCM will be output
from DIGITAL OUT jack for BD audio.
In “Mix Audio Output” mode with “HDMI Audio Out”
setting set to “Audio Mute” and “Digital Out”setting
set to “Bitstream”, DTS, DTS-HD and LPCM will be
output as Dolby Digital for BD audio. Refer to pages
14, 16.
You can also set “ BD Audio Mode” setting from the
setup menu. Refer to page 36. •
•
•
•
•
•
•
Adjusting the Picture
You can adjust the picture quality.
1
During playback, press [MODE].
2 Use [K / L] to select your desired item,
then use [s / B] to adjust the setting.
Noise Reduction
Black Level
Off
On s B
Black level
You can adjust the black level setting to make the black
parts of the pictures as bright as you prefer. You can
select “On” or “Off”
“On”: Makes the dark parts brighter.
“Off”: Shows the original picture as recorded.
Noise reduction
Reduces the noise of the playback picture.
“1”: Executes MPEG noise reduction which reduces the
block noise and mosquito noise on the subtitle on
movie.
“2”: Executes 3D noise reduction which detects and
deletes the noise by comparing each picture
frames.
“3”: Executes both MPEG noise reduction and 3D noise
reduction.
3
Press [RETURN ] repeatedly to exit.
Note
The setting remains even you turn off the unit.
For the picture output from HDMI OUT, “Black Level”
is not effective.
For BD, noise reduction is not effective. •
•
•
■
■
E5H40UD_NB500SL9_EN.indd 30 E5H40UD_NB500SL9_EN.indd 30 2008/04/14 13:57:32 2008/04/14 13:57:32