Onkyo DV-CP802 - Manual (Page 54)

54
Configuring the DV-CP802—Continued
Note:
• The Speaker Distance settings have no effect on
SACD (multichannel area and 2-channel area) and
196 kHz/176.4 kHz DVD-Audio.
Setting Levels With the Test Tone
AV Synchronization
When using progressive scanning you may find that the
picture and sound are out of sync. With this setting you
can delay the audio to correct this. There are three setup
memories (1, 2, 3) for storing settings for up to three
components. Memories 2 and 3 are already set at 50 ms,
which is a good staring point when compensating for the
video delay caused by a typical projector with a built-in
scaler.
Selecting the AV Synchronization
3 When you’ve finished, press the
[SETUP] button to exit setup, or
press the Left [
] button repeat-
edly to go back to the main setup
menu.
1 Use the Up and Down [ ]/[ ]
buttons to select Test Tone, and
then press the [ENTER] button.
The Test Tone settings appear onscreen.
2 Use the Up and Down [ ]/[ ]
buttons to select a speaker,
press the [ENTER] button, use
the Left and Right [
]/[ ] but-
tons to adjust the level, and then
press [ENTER] again.
Repeat for each speaker.
A test tone is output by each speaker as
it is selected.
Speaker levels can be adjusted in 1 dB
steps.
You cannot set the level of speakers that
are set to Off.
SETUP
Remote controller
ENTER
Remote controller
ENTER
Remote controller
Speaker Range Default
Front Left
–12 dB to
0 dB
0 dB
Center
Front Right
Surround
Right
Surround Left
Subwoofer
3 When you’ve finished, press the
[SETUP] button to exit setup, or
press the Left [
] button repeat-
edly to go back to the main setup
menu.
1 Use the Up and Down [ ]/[ ]
buttons to select setup 1, 2, or 3,
and then press the [ENTER] or
Right [
] button.
The parameters appear onscreen.
SETUP
Remote controller
ON STANDBY
SEARCH LAST M MEMORY CHAIN MODE
REPEAT
A-B
RANDOM
DISPLAY
MENU
SETUP
TOP MENU
RETURN
AUDIO ANGLE SUBTITLE
DISC 1 DISC 2 DISC 3
DISC 4 DISC 5 DISC 6
DISC SKIP DIMMER
RC-521DV
STEP/SLOW
CLEAR
OPEN/
CLOSE
PROGRESSIVE
ENTER
+10 0
1 2 3
4 5 6
7 8 9
SETUP
ENTER
/
Remote controller
ENTER