Oregon Scientific BPW120 - Manual (Page 12)

11
N
E
ABOUT OREGON SCIENTIFIC
EU-DECLARATION OF CONFORMITY
Settings
are
wrong
No user
memory
Date and time
are incorrect.
Measurement
unit (mmHg or
kPa) are
incorrect.
No records
display when
MEM/UP is
pressed.
The clock was
not set or
reset after
installing new
batteries.
The
measurement
unit was not
set or reset
after installing
new batteries.
No
measurements
have been
taken.
Reset the clock
( P6).
Reset the
measurement
unit (P6).
Take a
measurement,
then press
MEM/UP to
access the
memory.
EE xx
shows on the
display. A calibration
error
occurred. Retake the
measurement. If
the problem
persists, contact
the retailer or
our customer
service
department for
further
assistance.
Refer to the
warranty for
contact
information and
return
instructions.
PROBLEM SYMPTOM CHECK THIS REMEDY
P/N: 086L003591-148 REV1
Page 12 of 122
Visit our website (www.oregonscientific.com) to learn
more about Oregon Scienti fic products.
If you’re in the US and would like to contact our
Customer Care department directly, please visit:
www2.oregonscientific.com/service/support.asp
For international inquiries, please visit:
www2.oregonscientific.com/about/international.asp
Hereby, Oregon Scientific, declares that this Wrist Blood
Pressure Monitor (Model: BPW120) is in compliance with
EMC directive 2004/108/EC. A copy of the signed and
dated Declaration of Conformity is available on request via
our Oregon Scientific Customer Service.