Omega CNiS8DV - Manual (Page 50)

3.2.13 Ramp & Soak Menu
Alarm must be DISABLED if Ramp is ENABLED.
Figure 3.11 Flow Chart for Ramp and Soak Menu
ENTER RAMP AND SOAK MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until Display advances to RAMP Ramp
and SOAK Soak Menu.
RAMP ENABLE/DISABLE SUBMENU:
Press d 4) Display advances to “Ramp Enable/Disable” Submenu and
flashes
ENBL or DSBL.
Press b 5) Scroll through the available selections: “Enable” or “Disable”.
Press d 6) Display shows STRD stored message momentarily and then
advances to SOAK Soak Enable/Disable Menu.
If RAMP Disable was selected, display skips to the next menu
item (ID Code).
46
It is required that you put the controller in the Standby Mode for any
configuration change other than Set Points & Alarms.