Omega CNiS8DV - Manual (Page 47)

3.2.12 Output 2 Menu
Output 2 and Alarm 2 share the same contacts on the rear panel connector. If
Alarm 2 is Enabled, Output 2 is automatically Disabled.
Figure 3.10 Flow Chart for Output 2 Menu
ENTER OUTPUT 2 MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until Display advances to OUT2
Output 2 Menu.
Press d 4) Display advances to CTRL Control Type Submenu.
CONTROL TYPE SUBMENU:
Press d 3) Display flashes ON.OF On/Off, or PID PID.
Press b 4) Scroll through the available selections: “ON.OF” or “PID”.
Press d 5) Display shows STRD stored message momentarily and then
advances to AçTN only, if it was changed, otherwise press to
advance to AçTN Action Type Submenu.
The ON.OF control is a coarse way of controlling the Process. The “Dead Band”
improves the cycling associated with the ON.OF control. The PID control is best
for processes where the set point is continuously changing and/or tight control of
the Process Variable is required.
43
It is required that you put
the controller in the
Standby Mode for any
configuration change other
than Set Points & Alarms.