Omega CNiS8DV User Manual
Page 23
BUTTON SELECTION SUBMENU:
Press
d
12) Display flashes previous selection of
GROS Gross or PEAK
Peak.
Press
b
13) Scroll through the available selection
GROS or PEAK to the
selection of your choice.
Press
d
14) Display shows
STRD stored message momentarily and then
advances to
RDG Reading Configuration Menu.
If
GROS was selected, in the Run Mode pressing b button causes the
display to flash Gross value (value measured without zeroing of the
display).
If
PEAK was selected, in the Run Mode pressing b button causes the
display to flash Peak value.
0 - 20 mA current input used for process control only.
For 4 - 20 mA Input select 0 - 20 mA and adjust the Input/Reading
accordingly. To adjust 4 - 20 mA input, see example under
INPUT/READING Submenu.
3.2.5 Reading Configuration Menu
Figure 3.4 Flow Chart for Reading Configuration Menu
19
It
is required that you put the controller in the Standby Mode
for any configuration change other than Set Points & Alarms.