Omega CNiS8DV - Manual (Page 37)

3.2.9 Alarm 2 Menu
This unit is equipped with two physical outputs that can only be configured as
follows: Alarm 1 & Alarm 2, Alarm 1 & Output 2, Output 1 & Alarm 2, Output 1
& Output 2, Analog Out 1 & Alarm 2, Analog Out 1 & Output 2. Analog Out
available only if Analog Output Option board is factory installed.
Alarm must be DISABLED if Ramp is ENABLED.
Figure 3.7 Flow Chart for Alarm 2 Menu
ENTER ALARM 2 MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears.
Press d 2) Display advances to INPT Input Menu.
Press a 3) Press a, if necessary, until display advances to ALR2 Alarm 2
Menu.
Press d 4) Display advances to Alarm 2 ENBL Enable or DSBL Disable
Submenu.
33